Kontron AT890X Full-Size CLI Manual de usuario descargar pdf (Pagina 179)

AT8901/2/3 Quality of Service (QoS) Commands

Page 4 - 13 AT8901/2/3 CLI Reference Manual

To specify the match condition using a numeric value notation, the protocol number is

a standard value assigned by IANA and is interpreted as an integer from 0 to 255.

NOTE: This command does not validate the protocol number value against the

current list defined by IANA.

Default none

Format

match protocol {<protocol-name> | <0-255>}

Mode Class-Map Config

4.3.15 match source-address mac

This command adds to the specified class definition a match condition based on the

source MAC address of a packet. The <address

> parameter is any layer 2 MAC address

formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,

00:11:22:dd:ee:ff). The <macmask

> parameter is a layer 2 MAC address bit mask,

which may not be contiguous, and is formatted as six, two-digit hexadecimal numbers

separated by colons (e.g., ff:07:23:ff:fe:dc).

NOTE: This command is not available on the Broadcom 5630x platform.

Default none

Format

match source-address mac <address> <macmask>

Mode Class-Map Config

4.3.16 match srcip

This command adds to the specified class definition a match condition based on the

source IP address of a packet. The

<ipaddr> parameter specifies an IP address. The

<ipmask> parameter specifies an IP address bit mask and must consist of a contiguous

set of leading 1 bits.

Default none

Format

match srcip <ipaddr> <ipmask>

Mode Class-Map Config

4.3.17 match srcl4port

This command adds to the specified class definition a match condition based on the

source layer 4 port of a packet using a single keyword or numeric notation. To specify

the match condition as a single keyword notation, the value for

<portkey> is one of the

supported port name keywords (listed below). The currently supported

values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these translates

into its equivalent port number, which is used as both the start and end of a port range.

To specify the match condition as a numeric value, one layer 4 port number is required.

The port number is an integer from 0 to 65535.

Default none

Format

match srcl4port {<portkey> | <0-65535>}

Mode Class-Map Config

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 303 304

Comentarios a estos manuales

Sin comentarios

Kontron AT890X Full-Size CLI Manual de usuario Pagina 179

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Kontron AT890X Full-Size CLI