Kontron AT8404 CLI Manual de usuario descargar pdf (Pagina 325)

AT8404 Management Commands

Page 5 - 49 AT8404 CLI Reference Manual

Format

5.16.3 show boardinfo pll status

This command shows the PLL status.

5.16.4 show boardinfo pll config

This command shows the PLL configuration. The PLL configuration parameters are described below for the “set”

command.

5.16.5 set board clock bpl

This command enables/disables a clock driver to the backplane.

5.16.6 set board clock mux-amc

This command selects/deselects a source for a AMC clock (MUX configuration). The source may be the PLL (8kHz/

19,44MHz auto selected by clock-ekeying), a backplane clock or another AMC clock. Default source is PLL. Settings

are stored permamantly.

<src> = {pll|bpl<bplclk>|<amc>{tclkb|tclkd}}

<bplclk> = {clk1a|clk1b|clk2a|clk2b|clk3a|clk3b}

5.16.7 set board clock mux-bpl

This command selects/deselects a source for a Backplane clock (MUX configuration). Default source is amcb1 tclkb.

Settings are stored permanently.

Format set board pll tie {normal|adjust}

set board pll mode {normal|freerun}

set board pll oor {40_52_ppm|64_83_ppm}

set board pll reset {normal|reset}

set board pll source {none|clk1|clk2|clk3}

Mode Priviledged EXEC

Format show boardinfo pll status

Mode Priviledged EXEC

Format show boardinfo pll config

Mode Priviledged EXEC

Format set board clock bpl {clk1a|clk1b|clk2a|clk2b|clk3a|clk3b}

{enable|disable}

Mode Priviledged EXEC

Format set board clock mux-amc {amcb1|amcb2|amcb3|amcb4} {tclka|tclkc} <src>

Mode Priviledged EXEC

Format set board clock mux-bpl <bplclk> {amcb1|amcb2|amcb3|amcb4} {tclkb|tclkd}

1 2 ... 320 321 322 323 324 325 326 327 328 329 330 ... 372 373

Sin comentarios

Kontron AT8404 CLI Manual de usuario Pagina 325