Kontron AT8404 CLI Manual de usuario descargar pdf (Pagina 195)

AT8404 Quality of Service (QoS) Commands

Page 3 - 21 AT8404 CLI Reference Manual

3.4.11 policy-map rename

This command changes the name of a DiffServ policy. The <policyname> is the name of an existing DiffServ

class. The <newpolicyname> parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely

identifying the policy.

3.5 DiffServ Service Commands

Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you specified by using the

policy commands, to an interface in the incoming direction

The service commands attach a defined policy to a directional interface. You can assign only one policy at any one

time to an interface in the inbound direction. DiffServ is not used in the outbound direction.

This set of commands consists of service addition/removal.

The CLI command root is service-policy.

3.5.1 service-policy

This command attaches a policy to an interface in the inbound direction. The <policyname> parameter is the

name of an existing DiffServ policy. This command causes a service to create a reference to the policy.

3.5.1.1 no service-policy

This command detaches a policy from an interface in the inbound direction. The <policyname> parameter is the

name of an existing DiffServ policy.

Format policy-map rename <policyname> <newpolicyname>

Mode Global Config

Note: This command effectively enables DiffServ on an interface in the inbound direction. There is no

separate interface administrative 'mode' command for DiffServ.

Note: This command fails if any attributes within the policy definition exceed the capabilities of the

interface. Once a policy is successfully attached to an interface, any attempt to change the policy

definition, that would result in a violation of the interface capabilities, causes the policy change attempt

to fail.

Format service-policy in <policymapname>

Modes • Global Config

• Interface Config

Note: Each interface can have one policy attached.

Note: This command causes a service to remove its reference to the policy. This command effectively

disables DiffServ on an interface in the inbound direction. There is no separate interface administrative

'mode' command for DiffServ.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 372 373

Sin comentarios

Kontron AT8404 CLI Manual de usuario Pagina 195