Kontron AT8404 CLI Manual de usuario descargar pdf (Pagina 279)

AT8404 Management Commands

Page 5 - 3 AT8404 CLI Reference Manual

5.1.3 serviceport protocol

This command specifies the network management port configuration protocol. If you modify this value, the change

is effective immediately. If you use the bootp parameter, the switch periodically sends requests to a BootP server

until a response is received. If you use the dhcp parameter, the switch periodically sends requests to a DHCP server

until a response is received. If you use the none parameter, you must configure the network information for the

switch manually.

5.1.4 network parms

This command sets the IP address, subnet mask and gateway of the device. The IP address and the gateway must

be on the same subnet.

5.1.5 network protocol

This command specifies the network configuration protocol to be used. If you modify this value, change is effective

immediately. If you use the bootp parameter, the switch periodically sends requests to a BootP server until a

response is received. If you use the dhcp parameter, the switch periodically sends requests to a DHCP server until

a response is received. If you use the none parameter, you must configure the network information for the switch

manually.

5.1.6 network mac-address

This command sets locally administered MAC addresses. The following rules apply:

• Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered (b'0') or locally

administered (b'1').

• Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual address (b'0') or a

group address (b'1').

• The second character, of the twelve character macaddr, must be 2, 6, A or E.

A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').

Mode Privileged EXEC

Format serviceport protocol {none | bootp | dhcp}

Mode

Privileged EXEC

Format network parms <ipaddr> <netmask> [<gateway>]

Mode Privileged EXEC

Default none

Format network protocol {none | bootp | dhcp}

Mode Privileged EXEC

Format network mac-address <macaddr>

Mode Privileged EXEC

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 372 373

Sin comentarios

Kontron AT8404 CLI Manual de usuario Pagina 279