
Quality of Service (QoS) Commands AT8404
AT8404 CLI Reference Manual Page 3 - 38
3.10 Auto-Voice over IP Commands
This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands. The Auto-VoIP
feature explicitly matches VoIP streams in Ethernet switches and provides them with a better class-of-service than
ordinary traffic. When you enable the Auto-VoIP feature on an interface, the interface scans incoming traffic for the
following call-control protocols:
• Session Initiation Protocol (SIP)
• H.323
• Skinny Client Control Protocol (SCCP)
When a call-control protocol is detected, the switch assigns the traffic in that session to the highest CoS queue,
which is generally used for time-sensitive traffic.
3.10.1 auto-voip all
Use this command to enable VoIP Profile on the interfaces of the switch.
3.10.1.1 no auto-voip all
Use this command to disable VoIP Profile on the interfaces of the switch.
Term Definition
Rule Number The ordered rule number identifier defined within the IPv6 ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Match All Indicates whether this access list applies to every packet. Possible values are True or False.
Protocol The protocol to filter for this rule.
Source IP Address The source IP address for this rule.
Source L4 Port
Keyword
The source port for this rule.
Destination IP
Address
The destination IP address for this rule.
Destination L4 Port
Keyword
The destination port for this rule.
IP DSCP The value specified for IP DSCP.
Flow Label The value specified for IPv6 Flow Label.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.
Mirror Interface The slot/port to which packets matching this rule are copied.
Redirect Interface The slot/port to which packets matching this rule are forwarded.
Default disabled
Format auto-voip all
Mode Global Config
Format no auto-voip all
Mode Global Config
Comentarios a estos manuales