Kontron NSC2U IP Network Server Manual de usuario Pagina 44

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 152
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 43
NSC2U Server—Server Component Installations and Upgrades
Kontron IP Network Server NSC2U
Product Guide, rev. 1.4 December 2009
44
3.4.5.2 Removing a Processor
1. Loosen the four captive screws on the corners of the heat sink with a #2 Phillips
screwdriver. (Section 26, “A”)
2. Twist the heat sink slightly to break the seal between the heat sink and the
processor. (“B”)
3. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink
again.
Note: Do not force the heat sink from the processor. Doing so could damage the processor.
Figure 25. Cautions for Handling Processors
Figure 26. Removing the Heat Sink
TS000279
2
3
1
4
A
B
Vista de pagina 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 151 152

Comentarios a estos manuales

Sin comentarios