Kontron NSC2U IP Network Server Manual de usuario descargar pdf (Pagina 119)

Kontron IP Network Server NSC2U

December 2009 Product Guide, rev. 1.4

119

4. If the replacement board does not have these components pre-installed and you

are re-using components from the old server board, do the following:

a. Install the processor(s) and heat sink(s). For instructions, see Section 3.4.5.3,

“Installing a New Processor” on page 45.

b. Install all DIMMs. For instructions, see Section 3.4.3, “Installing DIMMs” on

page 41.

c. Install any I/O expansion modules or remote management modules. For

instructions see Section 4.3, “Installing an I/O Expansion Module” on page 55 or

Section 4.4, “Installing Intel® Remote Management Modules” on page 57.

5. Install the PCI riser assembly. For instructions, see Table 4.2.5, “Replacing the

Riser Card Assembly on the Server Board” on page 55.

Figure 104. Installing the Server Board

TS000537

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 151 152

Sin comentarios

Kontron NSC2U IP Network Server Manual de usuario Pagina 119