Kontron NSC2U IP Network Server Manual de usuario descargar pdf (Pagina 108)

NSC2U Server—5

Kontron IP Network Server NSC2U

Product Guide, rev. 1.4 December 2009

108

3. Remove the PCI fan assembly, including the flex cable that covers it. For

instructions, see Section 5.2.4, “Replacing the PCI Fans in the Fan Shroud” on

page 105.

4. Remove the CPU fan assembly. For instructions, see Section 5.2.1, “Removing the

CPU Fans” on page 100.

5. Disconnect all of the cables connected to the SFP board:

— SAS backplane power cable

— All four fan power cables

— Two power input cables from the power distribution board

—Flex cable

— RAID IBBU cable, if installed

— Front serial port cable

Use Section 33, “NSC2U Server System Cable Routing” on page 51 as a reference

for all of the connectors.

6. Remove the bridge board by opening the connector latch (Figure 94, “A”) and lifting

the board up from both ends. (“B”)

Figure 94. Removing the Bridge Board

TS000565

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 151 152

Sin comentarios

Kontron NSC2U IP Network Server Manual de usuario Pagina 108