Kontron NSW1U IP Network Server Manual de usuario descargar pdf (Pagina 48)

NSW1U Network Server—Optional Component Installation Procedures

Kontron IP Network Server NSW1U

Product Guide, rev. 1.4 December 2009

4.2.3 Installing the Drive in the Chassis

1. Use the guide pin to insert the drive tray into the front panel. Insert the primary drive in the right

bay.

2. Fasten the front panel screw and rear screw. (“B” and “C”)

3. Attach the combination data/power connector to the back of the drive and plug into the EFP

board. (See Figure 2 for cable routing.)

4. If this is the last task you are performing, replace the front panel, the processor air duct, and the

top cover of the chassis. Reconnect all the external devices and plug in the power cord(s).

Figure 27. Attaching a Hard Disk Drive to a Drive Tray

AF000820

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 109 110

Sin comentarios

Kontron NSW1U IP Network Server Manual de usuario Pagina 48