
Utility Commands AT8902M
AT8902M CLI Reference Manual Page 5 - 8
Broadcast Packets Received The total number of packets received that were
directed to the broadcast address. Note that this does not
include multicast packets.
Packets Transmitted Without Error The total number of packets transmitted
out of the interface.
Transmit Packets Errors The number of outbound packets that could not be
transmitted because of errors.
Collisions Frames The best estimate of the total number of collisions on
this Ethernet segment.
Time Since Counters Last Cleared The elapsed time, in days, hours, min-
utes, and seconds since the statistics for this port were
last cleared.
The display parameters, when the argument is “switchport” is as follows:
Broadcast Packets Received
The total number of packets received that were
directed to the broadcast address. Note that this does not
include multicast packets.
Packets Received With Error The number of inbound packets that contained
errors preventing them from being deliverable to a higher-
layer protocol.
Packets Transmitted Without Error The total number of packets transmitted
out of the interface.
Broadcast Packets Transmitted The total number of packets that higher-
level protocols requested to be transmitted to the Broad-
cast address, including those that were discarded or not
sent.
Transmit Packet Errors The number of outbound packets that could not be
transmitted because of errors.
Address Entries Currently In Use The total number of Forwarding Database
Address Table entries now active on the switch, including
learned and static entries.
VLAN Entries Currently In Use The number of VLAN entries presently occu-
pying the VLAN table.
Time Since Counters Last Cleared The elapsed time, in days, hours, min-
utes, and seconds since the statistics for this switch
were last cleared.
5.3.6 show interface ethernet
This command displays detailed statistics for a specific interface or for all CPU traffic
based upon the argument.
Format
show interface ethernet {<slot/port> | switchport}
Mode Privileged EXEC
The when you specify a value for <slot/port>, the command displays the following
information:
Packets Received
Total Packets Received (Octets) - The total number of
octets of data (including those in bad packets) received
Comentarios a estos manuales