Kontron CG2100 Carrier Grade Server Manual de usuario descargar pdf (Pagina 41)

Cable Number and Name

End 1 Connection

End 2 Connection

End 3 Connection

2: Flex Circuit /

Bridgeboard Assembly

SAS/SATA RAID

module

Baseboard

Front panel

board

3: LED/Switch Board

Power and Signal

Front panel

board

LED/switch

board

4: 80mm Fan Power and

Signal

Front panel

board

Ganged cable to

4 fans

5: 60mm Fan Power and

Signal

Front panel

board

Ganged cable to

2 fans

6: Serial Port (COM2)

Bridge board

Baseboard

7: TAM Front Panel TAM Module

Front Panel

Board

8: USB SD Flash SD Flash Card

Front Panel

Board

9: Alarms Cable TAM Module

Chassis Rear

Panel

4.2 Installing or Replacing Hard Disk Drives

Up to six hot-swappable SAS or SATA hard disk drives can be installed in your CG2100

server. The drives go into carriers that connect to the SAS/SATA backplane board once

the carriers with drives attached are inserted back into the drive bays. The CG2100

server ships with six drive carriers.

CAUTION: If you install fewer than six hard disk drives, the unused drive bays must

contain the empty carriers that ship with the server to maintain proper cooling.

The CG2100 server does not support all SAS/SATA hard disk drives. To see a list of

validated manufacturers and drive models, refer to the THOL. The latest version of

the THOL is located on the Kontron support website at http://us.kontron.com/support/.

(Search for CG2100, click on Product Downloads, then Compatibility Matrix).

You must remove the front bezel to add or replace a hard drive in one of the drive

bays. It is not necessary to remove the front chassis cover or to power down the

system. The hard drives are hot-swappable.

Removing an HDD Carrier from the Chassis

1. Remove the front bezel. For instructions, see “Removing the Front Cover“ in Section

3.2.

2. Select the drive bay where you want to install/replace the drive.

Drive bay 0 must be used first, then drive bay 1 and so on.

(Drive bay numbers are printed on the front panel below the drive bays.)

3. Remove the drive carrier by pressing the green button to open the lever. (Figure

26, “A”).

4. Pull the drive carrier out of the chassis.

Figure 26. Removing the Drive Carrier

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 109 110

Comentarios a estos manuales

Sin comentarios

Kontron CG2100 Carrier Grade Server Manual de usuario Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Kontron CG2100 Carrier Grade Server