
Utility Commands AT8402
AT8402 CLI Reference Manual Page 4 - 28
Mode Privileged EXEC
4.6.1.1 no license advanced
This command disables a particular feature. This command also disables the
corresponding show commands. The <key> parameter specifies the hexadecimal key
for the feature.
Format
no license advanced <key>
Mode Privileged EXEC
4.6.2 show key-features
This command displays the enabled or disabled status for all keyable features.
Format
show key-features
Modes Privileged EXEC
User EXEC
Function This is the name of the keyable component or feature.
Status Enabled or disabled.
4.7 Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system
time and date by using SNTP.
4.7.1 sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power
of two where <poll-interval> can be a value from 6 to 16.
Default 6
Format
sntp broadcast client poll-interval <poll-interval>
Mode Global Config
4.7.1.1 no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default
value.
Format
no sntp broadcast client poll-interval
Mode Global Config
4.7.2 sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may
set the mode to either broadcast or unicast.
Default disabled
Format
sntp client mode [broadcast | unicast]
Mode Global Config
Comentarios a estos manuales