Kontron AT8402 CLI Manual de usuario Pagina 144

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 253
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 143
Utility Commands AT8402
AT8402 CLI Reference Manual Page 4 - 4
4.1.9 show startupconfig
This command shows either the installed system images or configuration files. For
“startup” it shows the information about images and configuration files used at system
startup. For “all” it shows all the information about installed images/files and the
startup information.
Format
show startupconfig {initrd | startup | config | all}
Modes Privileged EXEC
4.2 ATCA commands
4.2.1 set board sensor threshold
This command sets a new threashold value for a sensor. The <record-id> (of SDR) for
a specific sensor is displayed by the related “show” command
Format
set board sensor threshold <record-id> <value-type> <value>
Mode Privileged EXEC
<Value-type>
lower-non-critical Set lower non-critical threshold value
lower-critical Set lower critical threshold value
lower-non-recover Set lower non-recoverable threshold value
upper-non-critical Set upper non-critical threshold value
upper-critical Set upper critical threshold value
upper-non-recover Set upper non-recoverable threshold value
4.2.2 set board ipmi-controller debug
This command enables temporary IPMI controller serial debug output on the
management serial console. .
Format
set board ipmi-controller debug {on | off}
Mode Privileged EXEC
NOTE: Use this command with care as it may render the console useless until a full
board reset is executed
4.2.3 set board device-id
This command sets the device ID for the board. The device ID is used in the
management device locator sensor (show boardinfo sensors).
Format
set board device-id <string>
Mode Privileged EXEC
4.2.4 set board fcap
This command enables or disables firmware capabilities.
handle: If the handle capability is enabled, then the functionality of the hotswap-
handle switch is disabled.
Vista de pagina 143
1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 252 253

Comentarios a estos manuales

Sin comentarios