
www.kontron.com
11
User Guide
COMe-bP5020
INTERCONNECTION
Gigabit Ethernet Up to five Gigabit Ethernet ports:
» One Gigabit Ethernet port through COMe MDI interface
» Up to four Gigabit Ethernet ports through SGMII interface
SATA Two SATA ports
SRIO Up to two x4 Serial RapidIO interfaces operating in host or agent configuration, depend-
ing on configuration
PCI Express Up to two x4 PCI Express interface operating in root complex configuration
If interface is configured for PCI Express, SRIO is not possible
Debug Interface One debug port
Serial Interface Up to four serial ports:
» 2x 4-wire UART interfaces (RxD, TxD, RTS, CTS), or
» 4x 2-wire UART interfaces (RxD, TxD)
GPIO Up to 12 GPIOs
Connectors
Onboard Connectors Two 220-pin connectors for interfacing with a carrier board
One JTAG/COP connector, J3, for debugging
microSD card Socket Standard microSD socket, J9, accepts microSD and microSDHC cards
Switch
DIP Switch One DIP switch for board configuration, SW1, consisting of four switches
LEDs
Module Health Monitor
LEDs
LED7: indicates Reset Status
LED9: indicates “Power Good” status
TIMER
Watchdog Timer Software-configurable, two-stage Watchdog with programmable timeout ranging from
125 ms to 4096 s in 16 steps
Serves for generating IRQ or hardware reset
System Timer There are several timers implemented in the CPU. For further information regarding
these timers, refer to the CPU reference manual from Freescale™.
THERMAL
Thermal Monitoring One onboard temperature sensor for monitoring the board temperature
GENERAL
Power Consumption Refer to Chapter 4, “Power Considerations” for information related to the power
consumption of the COMe-bP5020.
Temperature Range Operational: Refer to Chapter 5, “Thermal” for further information
Storage: -40°C to +70°C
Mechanical COM Express® basic
Dimensions 125 mm x 95 mm
Board Weight 99 grams (without heat spreader)
220 grams (with heat spreader)
Table 1: COMe-bP5020 Main Specifications (cont’d)
COMe-bP5020 SPECIFICATIONS
Comentarios a estos manuales