Kontron SMARC-sAT30 Manual de usuario Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 84
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
User’s Guide
www.kontron.com
SMARC
CARRIER
MXM3
CONNECTOR
(J40)
USB port power enable and over current logic implementation between the CPLD and SMARC sAT30 edge connector is
shown in the table below:
CPLD
SMARC sAT30 Edge Finger
Net Name
Notes
Pin #
Pin Name
Pin #
Pin Name
L9
IO_L9
P62
USB0_EN_OC#
EN_USB0_VBUS_OC#
USB Port0 power enable/over
current indication signal
K9
IO_K9
P67
USB1_EN_OC#
EN_USB1_VBUS_OC#
USB Port1 power enable/over
current indication signal
L10
IO_L10
P71
USB2_EN_OC#
EN_USB2_VBUS_OC#
USB Port2 power enable/over
current indication signal
Power distribution for external USB plug-in peripherals (USB memory sticks, cameras, keyboards, mice, etc.) is
typically handled by USB power switches such as the Texas Instruments TPS2052B, Micrel MIC2026-1 or similar devices
on the Carrier board. The Enable pin on the Carrier board USB power switch must be active high and the Over-Current
pin (OC#) must be open drain, active low (these are commonly available). No pull-up is required on the USB power
switch Enable or OC# line; they are tied together on the Carrier and fed to the Module USBx_EN_OC# pin. The pull-up is
on the Module.
5V Pwr
Switched
Pwr
USBx_VBUS
USBx_EN_OC#
Enable
TPS2052B
OC#
Figure 5: USB Power Distribution Implementation on Carrier
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 83 84

Comentarios a estos manuales

Sin comentarios