Kontron KTUS15-mITX - 1.1 Basic Manual de usuario descargar pdf (Pagina 34)

KTD-00774-G KTUS15/mITX Page 34 of 84

4.9 Printer Port Connector (PRINTER)

The signal definition in standard printer port mode is as follows:

Note

Pull

U/D

Ioh/Iol Type Signal

PIN# Signal Type Ioh/Iol

Pull

U/D

Note

2K2

(24)/24

OC(O)

STB#

AFD#

OC(O)

(24)/24

2K2

24/24

PD0

ERR#

2K2

24/24

PD1

INIT#

OC(O)

(24)/24

2K2

24/24

PD2

SLIN#

OC(O)

(24)/24

2K2

24/24

PD3

GND

PWR

2K2

24/24

PD4

GND

PWR

2K2

24/24

PD5

GND

PWR

2K2

24/24

PD6

GND

PWR

2K2

24/24

PD7

GND

PWR

2K2

ACK#

GND

PWR

2K2

BUSY

GND

PWR

2K2

GND

PWR

2K2

SLCT

GND

PWR

The definition of the signals in standard Centronics mode (SPP) with a printer attached is as follows:

Signal Description

PD7..0 Parallel data bus from PC board to printer. The data lines are able to operate in PS/2

compatible bi-directional mode.

SLIN# Signal to select the printer sent from CPU board to printer.

SLCT Signal from printer to indicate that the printer is selected.

STB# This signal indicates to the printer that data at PD7..0 are valid.

BUSY Signal from printer indicating that the printer cannot accept further data.

ACK# Signal from printer indicating that the printer has received the data and is ready to accept

further data.

INIT# This active low output initializes (resets) the printer.

AFD# This active low output causes the printer to add a line feed after each line printed.

ERR# Signal from printer indicating that an error has been detected.

PE# Signal from printer indicating that the printer is out of paper.

The printer port additionally supports operation in the EPP and ECP mode.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 83 84

Comentarios a estos manuales

Sin comentarios

Kontron KTUS15-mITX - 1.1 Basic Manual de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Kontron KTUS15-mITX - 1.1 Basic