Kontron KTAM3874-pITX Manual de usuario descargar pdf (Pagina 13)

KTD-S0057-I Page 9 U-Boot Setup

KTAM3874/pITX Software Guide

2.7 Save Command

This is one of the most important sub-commands. Without this calling all Setup changes are lost after

power off. The save instruction writes the temporary Setup settings into the non-volatile memory device

(EEPROM).

Syntax:

setup save <Enter>

2.8 Summary Command

This Setup command gives a quick overview about all actual settings.

Syntax:

setup summary <Enter>

Example:

DISPLAY PART:

First boot display : hdmi

Second boot display : lcd

Boot display mirror mode : enabled

LCD panel resolution : sxga

LCD panel mapping : ldi

Backlight output control : pwm

Backlight enable level : high

Backlight brightness : 255

DEVICES PART:

mPCI Express interface : enabled

Audio interface : disabled

LAN interfaces : enabled

SATA interface : disabled

CAN interface 0 : enabled

CAN interface 1 : enabled

UART interface 5 : rs485

GPIO/TIMER4+6 interface : gpio

GPIO/TIMER5+7 interface : gpio

GPIO/UART2 interface : uart

GPIO/UART4 interface : gpio

GPIO/SPI3 interface : gpio

2.9 ShowDID Command

The showdid command provides the necessary information for checking the DisplayID

values. Some addi-

tional messages are possible, for example:

No DisplayID record present !

ATTENTION: DisplayID record is not activated !

Syntax: setup showdid <Enter>

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 292 293

Sin comentarios

Kontron KTAM3874-pITX Manual de usuario Pagina 13