Kontron TIGW1U Carrier Grade Server Manual de usuario descargar pdf (Pagina 20)

TIGW1U server—Features

Kontron Carrier Grade Server TIGW1U

Product Guide, rev. 1.3 December 2009

2.7 Hard Disk Drives

The TIGW1U server chassis provides three hot-swappable hard drive tray assemblies at

the front of the chassis.

For information on how to install these drives, see Section 3.3.1, “Installing or

Replacing a Hard Drive”.

Note: The TIGW1U server does not support all SAS hard drives. For a list of validated hard

drive manufacturers and hard drive types, see the Tested Hardware and Operating

Systems List (THOL) on the Kontron support website at

http://us.kontron.com/support/.

(Search for TIGW1U, click on Product Downloads, and then Compatability Matrix.)

Each drive can consume up to 17 W of power. Drives must be specified to run at a

maximum ambient temperature of 45° C.

2.8 Riser Card Assembly

The TIGW1U server default riser card assembly contains a PCI-X riser card. There is

also a PCI Express (PCIe) version available as a separately orderable accessory.

The S5000PHB server board implements a PCI super slot that contains the signals

necessary for a PCI/PCI-X or PCIe expansion slot. One of two different low-profile riser

cards is inserted into the super slot to access the appropriate signals and provide the

appropriate connector for a PCI/PCI-X or PCIe riser card. (See Figure 7 for this

location.) The Carrier Grade Server TIGW1U is designed to accommodate full-length,

full-height PCI add-in cards with the card’s I/O bracket accessible through an opening

in the rear panel of the system.

The PCI/PCI-X riser card supports speeds of 33 or 66 MHz PCI and 100 or 133 MHz

PCI-X.

The PCIe riser card implements a x8 link interface, and can be used with add-in cards

that implement x1, x4, or x8 interfaces.

See Section 3.4.5, “Installing or Replacing a PCI Add-in Card” for how to install a PCI

add-in card or how to replace the default PCI-X riser card assembly with a PCIe version.

2.8.1 PCI/PCI-X Riser Card

The PCI/PCI-X riser card, which is the default riser card installed in the assembly,

supports one 3.3 V 64-bit slot and speeds of 33 or 66 MHz for PCI and 66, 100, or

133 MHz for PCI-X. The bus speed varies from 66 MHz to 100 MHz depending on the

I Dual-port LAN connector X BIOS Bank Select jumper (J1G1)

J Dual USB 2.0/RJ45 serial port B connector Y Intel

ESB2-E I/O controller hub

K Telco alarms connector Z CMOS Clear jumper (J1F1)

L Video connector AA BMC Force Update jumper (J1E3)

M PS/2 keyboard and mouse connector BB 3-Pin IPMB header

N FBDIMM slots CC Processor select jumper

OIntel

500P Memory Controller Hub (MCH) DD

Intel

Remote Management Module 2

(Intel

RMM2) connector

Item Description Item Description

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Comentarios a estos manuales

Sin comentarios

Kontron TIGW1U Carrier Grade Server Manual de usuario Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Kontron TIGW1U Carrier Grade Server