Kontron NSN2U IP Network Server Manual de usuario descargar pdf (Pagina 59)

5.3 Replacing the Bridge Board

The NSN2U server bridge board provides the fan tach and the SAS/SATA signal paths

between the front panel board and the baseboard. Because it spans both the front panel

board and the baseboard, several components must be removed before you can replace the

bridge board:

• Both top chassis covers

• The riser card assembly

• The processor air duct

• The protective cover on the front panel board

• The flex circuit cable connection

• The serial port connection

CAUTION: Before replacing any of the boards on the NSN2U server, you must first take

the server out of service, turn off all peripheral devices connected to the

server, turn off the server by pressing the power button, and unplug the power

cord(s) from the system and wall outlet.

When handling the FP board, observe the normal safety and ESD precautions. See

Appendix A: Safety Information for more information.

For the location of the cables connected to the bridge board, see Figure 7 and Table

Removing the Bridge Board

To remove the bridge board from the chassis:

1. Remove both of the chassis covers. For instructions, see “Removing the Chassis

Covers” in Section 3.2.

2. Remove the riser card assembly. For instructions, see “Removing the Riser Card

Assembly” in Section 3.2.

3. Remove the processor air duct. For instructions, see “Removing the Processor Air

Duct” in Section 3.2.

4. Unfasten the black protective cover on top of the FP board.

5. Disconnect the SAS/SATA flex circuit cable from the bridge board. (Figure 48, “A”)

6. Disconnect the serial port cable from the bridge board. (“B”)

7. Remove the black plastic riser card assembly/bridge board guide bracket by

loosening the two screws that secure it to the chassis base. (“C”)

Figure 48. Removing Cables and Guide Bracket from the Bridge Board

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 102 103

Sin comentarios

Kontron NSN2U IP Network Server Manual de usuario Pagina 59