Kontron M2M Smart Services Developer Kit User Manual Manual de usuario descargar pdf (Pagina 35)

5.10 Re-installing the Chassis Covers

Follow this procedure (Using a torque screwdriver (torque spec. 1.5 inch/pound))

1. Position the cover over the open unit so that the mounting brackets align and the top, bottom and side are

aligned and ready for reassembly.

2. Screw the 2 screws in the bottom using a Phillips screw driver.

3. Screw the 2 screws in the top using a Phillips screw driver.

4. Screw the 1 screw on the end using a Phillips screw driver.

5. The finished unit should appear as below; note that the spacer is no longer installed in the M2M System.

Figure 33. The M2M System with the 3G module fully installed and spacer removed

Note: The cover needs to slide out slightly before lifting off the cover (the connectors extend into the

thickness of the flange)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 48 49

Sin comentarios

Kontron M2M Smart Services Developer Kit User Manual Manual de usuario Pagina 35