Kontron KTQ67-FLEX Manual de usuario descargar pdf (Pagina 44)

KTQ67 Users Guide

KTD-N0829-G Page 44

6.7 Serial COM2 – COM4 Ports (J19, J20, J21)

Three RS232 serial ports are available on the KTQ67 via pin-row connector. (COM 1 is in the IO area

and is based on standard DB9 connector, see other section for more info).

The typical definition of the signals in the COM ports is as follows:

Signal Description

TxD

Transmitted Data, sends data to the communications link. The signal is set to the marking

state (-12V) on hardware reset when the transmitter is empty or when loop mode operation is

initiated.

RxD Received Data, receives data from the communications link.

DTR

Data Terminal Ready, indicates to the modem etc. that the on-board UART is ready to

establish a communication link.

DSR Data Set Ready, indicates that the modem etc. is ready to establish a communications link.

RTS

Request To Send, indicates to the modem etc. that the on-board UART is ready to exchange

data.

CTS Clear To Send, indicates that the modem or data set is ready to exchange data.

DCD Data Carrier Detect, indicates that the modem or data set has detected the data carrier.

RI Ring Indicator, indicates that the modem has received a ringing signal from the telephone line.

The pinout of Serial ports COM2 (J20), COM3 (J19) and COM4 (J21) is as follows:

Note

Ioh/Iol

Type

Signal

Type

Ioh/Iol

Note

DCD

DSR

RxD

RTS

TxD

CTS

DTR

PWR

GND

PWR

Note 1: The COM2, COM3 and COM4 5V supply is fused with common 1.1A resettable fuse.

DB9 adapter cables (PN 821016 200mm long and 821017 100mm long) are available for implementing

standard COM ports on chassis.

Internal Connectors

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 136 137

Comentarios a estos manuales

Sin comentarios

Kontron KTQ67-FLEX Manual de usuario Pagina 44

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Kontron KTQ67-FLEX