Kontron AT8902 Full Size CLI Manual de usuario descargar pdf (Pagina 229)

AT8901/2/3

Page 5 - 33 AT8901/2/3 CLI Reference Manual

Failed Unicast Requests Number of failed requests from server.

5.9 DHCP Server Commands

This section describes the commands you to configure the DHCP server settings for the

switch. DHCP uses UDP as its transport protocol and supports a number of features

that facilitate in administration address allocations.

5.9.1 ip dhcp pool

This command configures a DHCP address pool name on a DHCP server and enters

DHCP pool configuration mode.

Default none

Format

ip dhcp pool <name>

Mode Global Config

5.9.1.1 no ip dhcp pool

This command removes the DHCP address pool. The name should be previously

configured pool name.

Format

no ip dhcp pool <name>

Mode Global Config

5.9.2 client-identifier

This command specifies the unique identifier for a DHCP client. Unique-identifier is a

valid notation in hexadecimal format. In some systems, such as Microsoft DHCP

clients, the client identifier is required instead of hardware addresses. The unique-

identifier is a concatenation of the media type and the MAC address. For example, the

Microsoft client identifier for Ethernet address c819.2488.f177 is 01c8.1924.88f1.77

where 01 represents the Ethernet media type. For more information, refer to the

“Address Resolution Protocol Parameters” section of RFC 1700, Assigned Numbers

for a list of media type codes.

Default none

Format

client-identifier <uniqueidentifier>

Mode DHCP Pool Config

5.9.2.1 no client-identifier

This command deletes the client identifier.

Format

no client-identifier

Mode DHCP Pool Config

5.9.3 client-name

This command specifies the name for a DHCP client. Name is a string consisting of

standard ASCII characters.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 303 304

Sin comentarios

Kontron AT8902 Full Size CLI Manual de usuario Pagina 229