Kontron CP390 Manual de usuario descargar pdf (Pagina 18)

CP390 Installation

ID 19976, Rev. 0200Page 2 - 2 ® PEP Modular Computers GmbH

2. Installation

2.1 Board Installation

PMC Module Installation

1. Place the EMC gasket on the bezel of your PMC-Module

2. Unscrew the stand-off, which is positioned at the PCI-Bridge

3. Push the PMC bezel into the window of the front-panel of the CP390 and plug the

connectors together.

4. Use three screws (M2.5 x 6mm) to fix the board

Caution!

If you are using the non-hotswap version of the CP390, please

switch off the target system before installing the board in a free

slot. Failure to do so could endanger your life/health and may

damage your board or system.

ESD Equipment!

Your carrier board and PMC module contain electrostatically sen-

sitive devices. Please observe the necessary precautions to avoid

damage to your board:

• Discharge your clothing before touching the assembly. Tools

must be discharged before use.

• Do not touch components, connector-pins or traces.

• If working at an anti-static workbench with professional dis-

charging equipment, please do not omit to use it.

Note:

In order to support an active PMC carrier and, therefore, to

comply with the CPCI specification, it was necessary to

place the PCI-to-PCI bridge in the position where a socket

for mounting a stand-off would normally be (PMC specifica-

tion). As a result, the second stand-off has been omitted.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Sin comentarios

Kontron CP390 Manual de usuario Pagina 18